![]() ![]() Next, you should see a progress icon with a message indicating that scanning has started, as shown below.Īfter a few seconds of scanning, the home screen should list the available in-range devices. Note: If the Beacon list remains empty after 15 seconds of scanning, we can assume there are no RadBeacon E devices in range. The Beacon Detail screen contains fields for configuring the beacon parameters, and fields that display beacon status information. To edit the beacon name, start by tapping on the beacon name edit box under the “Beacon Name” label.The beacon name can be set to a maximum length of 32 characters. If a name containing more than 32 characters is applied as part of the changes, it will be ignored. The beacon information section displays status information about the connected device. The “Version” field indicates the firmware version of the beacon. The “MAC address” fields corresponds to the address of the beacon. The “Battery” field shows the current percentage of remaining battery in the device. To start configuring the slots, tap the “Enable” toggle switch to the ON position. Once the slot has been enabled, the list of slot configuration options will expand as shown in the figure below. The “Enabled” switch is used for starting/stopping advertisement activity on the slot. The “Channels” option is used for switching advertisement on/off on the 3 individual Bluetooth™ Low Energy advertising channels. The “Advertising interval” value is used for configuring the frequency rate at which the slot advertises data. The recommended interval value for iBeacon advertisement is 100ms. Increasing the “Advertising Interval” value increases the lifespan of the RadBeacon E4’s battery. The “Transmit Power” value determines the strength of the wireless signal transmitted by the RadBeacon E4. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |